Using an SRH-2D Restart File

Do you have an SRH-2D project that is going to take a long time to run? If you don't want your computer tied up for hours, or even days, an SRH-2D project can broken up into smaller model runs that build on each other. This is done by using a restart file or hot start file.

In SRH-2D, a restart file can be specified for the initial wet/dry condition of the simulation. The restart file must have been generated from a previous simulation run that used the same mesh. Several output options exist for creating restart files including: creating them at a regular interval, at a specified list of times, or a single restart file at the end of the simulation.

When SRH-2D does a model run, it creates a series of files for each time step. These restart files are named [casename]_RSTn.dat where n corresponds to the time index. The time series output index file is named [casename]_TSO.dat and holds a list that matches the restart files to a specific time step.

When a restart file is used as an initial conditions hot start file, the previously computed hydraulic conditions from the restart file will always be applied to the start time of a simulation.

To use a hot start condition, do the following:

1. Run an SRH-2D simulation to completion.
2. In the output files for the model run, locate the file ending with "TSO.dat" and open it in a text editor.
3. In the TSO file, locate the time step where you want to use to start your next next simulation run.
4. In you SMS project, duplicate your simulation.
5. Open the SHR-2D Model Control dialog for your new simulation.
6. In the Initial Conditions section, select the Restart File option.
7. Press the Select button to browse to your restart file.

SRH-2D will now use the conditions from the restart file when you perform your next model run. Now that you know how to use a restart file for an initial condition in SRH-2D, try it in the Community Edition of SMS today!